Pro-Ductomatic (Starter Line)
The Pro-Ductomatic is the basic machine needed for a duct shop, whether used as a stand-alone machine to produce duct blanks or as the heart of a Fabriduct line.
The Pro-Ductomatic has the capacity to remove coil set, bead, and notch for two-piece or wrap duct, and cut off in a feed-to-stop shearing process. There is no minimum cut length or minimum on notch spacing.
PC-based controls ensure consistent quality of leg lengths and feeds.
Pro-Fabriduct
Produces commercial and residential ducting
Modular design with 11 integrated flexible workstations
"U" or "Z" configurations to optimize floor space
Notches vees and corners
Forms pittsburgh, snap-lock, TDC, slip & drive seams and joints
Automated application of glue and insulation
Automated production control with integrated PC
Operator programmable. The controller will store up to 100 programs for easy recall
Modem included for remote factory support
Processes flat sheets, 4-piece duct, "L" duct sections, "U" duct sections and wrap around duct sections